Detailed Explanation Of Low Cement Castable Baking Method

Apr 15, 2025

Leave a message

    Low cement castable have high density and low porosity due to their low cement content (usually 3%~8%). Therefore, special attention should be paid to moisture discharge and thermal stress control during the baking process to avoid cracking or structural damage.The following are the key steps and precautions for baking low cement castables:

    1.Preparation before baking

Ensure that the castable has been fully cured naturally (usually 24 to 48 hours) to give it initial strength. If wet curing is used, stop and dry the surface moisture naturally before baking. Check whether the castable has cracks or loose parts and repair them if necessary. Use a controllable heat source such as a hot air generator, gas burner or electric heater.

    2. Baking system

news-857-440

 

    3.Precautions

    Avoid local overheating and ensure that the heat source is evenly distributed. If the temperature fluctuates by more than ±20℃, stop heating and adjust. Open the exhaust holes of the furnace or leave gaps to prevent steam accumulation. If there is a popping sound or local peeling, stop heating immediately and extend the insulation time. In severe cases, the temperature needs to be lowered to below 100℃, checked and repaired before baking again. After baking, cool naturally to room temperature and avoid forced cooling.

    The baking of low cement castable must strictly follow the principle of "slow heating and long heat preservation" to ensure the release of moisture gradient and structural stability. Scientific baking can maximize material performance and extend service life, otherwise it is easy to cause defects or even failure. During operation, it is necessary to flexibly adjust the material characteristics and working conditions. You can contact us at any time, and the technical team of Haixin Refractory can provide you with professional guidance.