Analysis Of Thermal Shock Resistance Of High Alumina Refractory Brick

Apr 13, 2025

Leave a message

    The thermal shock resistance of high alumina refractory brick is one of its key performance indicators, which determines the service life and stability of the material under rapid temperature changes.

    Thermal shock resistance refers to the ability of a material to resist thermal stress caused by sudden temperature changes without breaking. When high-alumina bricks are cooled or heated rapidly, thermal stress is generated inside due to the temperature difference. When the stress exceeds the strength of the material, it causes cracking. Thermal shock resistance is determined by the thermal expansion coefficient, thermal conductivity, elastic modulus and microstructure.

    The thermal shock resistance of high-alumina refractory bricks is at a medium level, which can be significantly improved through composition optimization and structural design. So how to improve its thermal shock resistance?

    Using Grade I bauxite clinker and fused white corundum powder as raw materials, adding an appropriate amount of expansion agent, and after molding and heat treatment at 800℃, high-alumina bricks with good thermal shock stability can be obtained. First, add 50% chemical binder to the coarse particles, mix for 3-5 minutes, and then add fine powder, composite expansion agent and the rest of the chemical binder. The particle size composition of the mud is as follows: 5~3mm18.4%, 3~1mm26.7%, 1~0.5mm3.5%, 0.5~0.1mm8.2%, <0.1mm43.2%, moisture 3%, trapped for more than 2h.

    The bricks are formed on a 300t friction brick press with a bulk density greater than 2.85g/cm3. After being dried at 160℃, the bricks are heat treated in a downdraft kiln at 800℃ for 4h.

    The physical and chemical indicators of this brick are as follows: Al2O3: 77.01%, SiO2: 13.71%, apparent porosity: 20.4%, room temperature compressive strength: 57.4MPa, load softening temperature: 1530℃; 1500℃, 2h re-burning line change rate +3.7%. Thermal shock stability (1100℃, water cooling) is greater than 10 times. This brick is used for the top of a 5t electric furnace without peeling or falling off.

    In response to the demand for thermal shock resistance of high alumina refractory brick, Haixin Refractory Materials has launched a series of thermal shock-resistant enhanced high-alumina bricks, combining cutting-edge technology and engineering practice to provide long-term and stable solutions for high-temperature equipment.