How To Adjust The Construction And Maintenance Of Lightweight Acid Resistant Castables in High Temperature Environment

Oct 21, 2025

Leave a message

    When the construction environment temperature is too high, exceeding 30°C, the construction and maintenance of lightweight acid resistant castables need to be adjusted in a targeted manner to avoid problems such as insufficient strength, cracking, and decreased corrosion resistance caused by abnormal temperature. The following are specific adjustment measures:

    In a high temperature environment, water evaporates too quickly, which can easily lead to rapid crusting on the surface of the castable, insufficient internal density, and even shrinkage cracks. It is necessary to control water loss throughout the entire process from construction to maintenance.

Construction phase adjustments

    Store the dry material and mixing water of the lightweight acid resistant castable in a cool place in advance. If necessary, cool the dry material to ensure that the raw material temperature is ≤30°C. Mixing water can be groundwater or ice water, and the water temperature should be controlled at 10-20°C to reduce the initial temperature of the slurry after mixing.

    Shorten the mixing time to prevent the slurry from heating up further due to friction. Also, strictly control the mixing water volume, slightly increasing it by 5% to 10% compared to the normal temperature volume to prevent rapid evaporation of water and resulting in insufficient fluidity. Mix in batches and apply quickly: Each mixing volume should be sufficient to complete the pouring within 30 minutes. Avoid leaving the slurry at high temperatures for too long.

    Sprinkle water on the construction base to cool it down before pouring to reduce the water loss of the slurry caused by heat absorption of the base.

    The vibration time is shortened by 20% compared to normal temperature to avoid excessive vibration that may cause sinking of aggregate and excessive water seepage on the surface; smooth the surface with a trowel immediately after vibration to prevent surface cracking caused by wind and sun.

Maintenance stage adjustment

    Cover with moisturizing material within one hour of pouring. Preferably, use a double layer of plastic film and wet sacks to ensure the surface remains moist and isolate the material from hot air and direct sunlight. Check the moisturizing layer every one to two hours. If the sacks are dry, rehydrate them immediately. In high-temperature, high-light environments, erect a sunshade or shade net to maintain the ambient temperature below 35°C.

    The total curing period should be extended by 20% to 30% compared to normal temperature to ensure sufficient internal hydration.

For water glass bonded castables, the acidification treatment time can be postponed to 5 days after curing, and dilute acid at room temperature should be used for acidification. Cover with a wet cloth for 1 hour after each spraying to enhance the acidification effect.

    When drying after curing, the initial temperature should be controlled below 50°C and the heating rate should be reduced to ≤10°C per hour to prevent cracking caused by rapid escape of internal moisture due to high temperature.

    The key to the construction and maintenance of lightweight acid resistant castables in high-temperature environments is temperature control and water conservation. This is achieved by cooling the raw materials, shortening the construction cycle, and enhancing moisture retention to prevent rapid water loss. Post-construction inspections of the castable should be increased, with cracks and sanding issues addressed promptly to ensure that final performance meets standards.