The preparation process of plastic is as follows: batching → mixing, degassing and extruding into strips → cutting or extruding into blocks, cakes or other desired shapes → sealed storage → supply for use. Some also use other compaction methods, such as shaking and compacting, to make material blocks.
Plastic does not require special techniques during construction. When used to make furnace linings, the plastic can be taken out of a sealed container, laid on hanging bricks or hooks, and compacted in layers (each layer is 50-70mm thick) with a wooden mallet or air hammer. Surface processing can be carried out before hardening. To facilitate the drainage of moisture, air vents are added at regular intervals. Finally, leave expansion and contraction joints according to the design. If used to make an integral furnace cover, it can be constructed on the bottom mold first, dried, and then lifted.
Plastic is mainly used in various heating furnaces, homogenization furnaces, annealing furnaces, carburizing furnaces, hot air furnaces, sintering furnaces, etc. It can also be used for the furnace cover of small electric arc furnaces, the burner of high-temperature furnaces, and other similar parts. The usage temperature mainly varies depending on the quality of the granular and powdered materials used: ordinary clay can be used as plastic for 1300-1400 ℃; High quality plastic for use at 1400~1500 ℃; High alumina plastic is used at temperatures ranging from 1600 to 1700 ℃, and even higher; Chromium based plastic can be used at 1500-1600 ℃.
Preparation and use of plastic materials
Aug 13, 2024
Leave a message
