At present, there are three methods to produce light mullite brick at home and abroad: foam method, additive burning method and gasification method. The manufacturing of light mullite brick with foam method is to mix the foaming agent, stabilizer and water in a certain proportion to make foam liquid, and then mix with slurry to produce light mullite brick with high porosity through casting, curing, drying, baking and firing. Although it can produce high-quality lightweight mullite bricks, its process procedures are complex, the production cycle is long, the production efficiency is low, and the cost is high. The additive burning method for producing lightweight mullite bricks involves adding a portion of combustible additives, such as sawdust and poly, to the ingredients
Styrene, coke, and other combustible additives rapidly burn during brick firing, and the positions of the additives become pores. This type of brick with high porosity and low density becomes a lightweight mullite brick. This method has a simple production process, short production cycle, low cost, and high production efficiency. Gasification method for producing lightweight mullite bricks refers to introducing substances that can react chemically to produce gas in the ingredients, using chemical methods to obtain bubbles, thereby producing bricks with high porosity and low density. The production process of this method is simpler than that of the foam method, the production cycle is longer, the cost is higher, and it is rarely used in actual production. According to the actual situation of the special refractory material factory, the additive burnout method is finally adopted to produce lightweight mullite bricks.
There are three molding methods for producing lightweight mullite bricks using the additive burning method: vibration, pouring, and manual pounding molding. Vibration molding produces lightweight mullite bricks with a short cycle and high production efficiency, but the quality (especially density) is difficult to control; Long pouring molding cycle, low production efficiency, and high cost (mold cost); Hand pounding molding has low production efficiency, low cost, high labor intensity, and difficult quality control. Considering the actual situation of our factory, we have decided to adopt a new process - high-frequency vibration pressure forming, which applies a certain amount of pressure while vibration forming. Its production cycle is short, production efficiency is high, cost is low, and its molding time and pressure are strictly controlled. The quality of the products produced is satisfactory.
Determination of molding method for mullite bricks
Aug 20, 2024
Leave a message
