The daily maintenance of high alumina refractory bricks should be combined with their use environment and damage mechanism. Through regular inspections, surface cleaning, local repairs, thermal system optimization and other methods, potential problems can be discovered and dealt with in a timely manner to extend the service life of the bricks. The following are specific maintenance methods:
1. Regular Inspection And Status Assessment
Focus on checking the furnace door, arch, brick joints, expansion joints and hot spots affected by air flow and slag erosion, and observe whether there are new cracks on the brick surface or expansion of existing cracks; whether there is layered shedding, edge wear or melting pits on the brick surface; whether the masonry is misaligned, bulging or the brick joints are enlarged.
Use infrared temperature measuring instruments to regularly scan the surface temperature of bricks and compare the temperature distribution under normal working conditions. Abnormally high temperature areas may indicate internal erosion or shedding. Use ultrasonic instruments to detect internal defects in key parts to determine whether the brick thickness is thinning or voids are formed. Monitor the concentration of corrosive gases such as CO and SO₂ in the furnace to assess the risk of erosion.
2. Surface Cleaning And Protection
Use a steel shovel, pneumatic pick, high-pressure water, compressed air, etc. to remove slag, glass liquid or dust adhered to the surface of the bricks to prevent the attachments from reacting with the bricks under long-term high temperature to aggravate erosion. Avoid hitting the bricks hard during cold cleaning. Control the temperature gradient during hot cleaning to prevent the bricks from cracking due to rapid cooling. Parts that are frequently washed by slag or oxidized at high temperature need to be sprayed with protective coating.
3.Local Repair Technology
In case of small area damage or emergency repair, hot repair can be adopted, that is, the furnace can be operated without stopping. The repair material can be selected from high-aluminum ramming material or low-cement high-aluminum castable material. During operation, attention should be paid to cleaning the slag and loose bricks at the damaged part to form a rough interface. The interface agent should be applied to the bonding surface between the repair material and the original brick to ensure a firm bond. After repair, the furnace temperature should be controlled to rise slowly to avoid cracking of the repair material due to rapid heat.
Large-area damage or deep erosion of bricks requires cold repair, that is, stopping the furnace. During operation, the damaged bricks need to be removed and the masonry surface cleaned to ensure that there is no residual mud or debris. Use high-aluminum bricks of the same grade as the original bricks, check the matching degree of brick joints before pre-laying, use high-aluminum mud for masonry, and the brick joints should be ≤2mm. Expansion joints (joint width 2~3mm) need to be left at the junction of the new bricks and the old bricks, and filled with ceramic fiber or refractory mud.
4.Optimization of Thermal System
Control temperature fluctuations, avoid rapid cooling and heating, reduce thermal stress of bricks, and avoid local temperature exceeding the refractoriness of bricks. The temperature of brick surface can be reduced by adding water cooling jackets or adjusting the negative pressure of the kiln. Regularly analyze the composition of slag, reasonably adjust the alkalinity, and reduce the erosion of high alumina refractory bricks. Strengthen the control of corrosive gases and reduce the infiltration of reducing gases such as CO and H2.
5.Maintenance Records And Trend Analysis
Establish maintenance files to record problems found during each inspection, repair locations, material usage, and furnace condition data. By comparing historical data, analyze the trend of brick damage, and formulate maintenance plans in advance to avoid sudden failures.
The daily maintenance of high alumina refractory bricks must follow the principle of "prevention first, prevention and treatment combined". At the same time, combined with the working characteristics of different industrial kilns (such as metallurgy, building materials, and chemical industry), a personalized maintenance plan can be formulated to significantly improve the use efficiency of refractory materials and the stability of kiln operation.
